Lead/Copper and Other Water Quality Issues
It seems like drinking water quality is a news story every day. The Division of Water Works very hard to produce high quality drinking water for our community. We operate under a permit from the Ohio Environmental Protection Agency and our employees are certified by the State of Ohio as Water Plant Operators or Water Distribution System Operators. Every day the water is sampled before leaving the water plants to ensure that we are in compliance with the United States Environmental Protection Agency Maximum Contaminate Limits (MCLs). We provide an annual report to all our consumers that outlines our operations and water quality. The City works with Hydrogeologists certified by the State of Ohio in the Brownfield Program to advise us on aquifer and water quality matters. Some specific water quality issues are listed below.
LEAD SERVICE LINES
The Ohio Environmental Protection Agency required every water system to evaluate the number of lead service lines in their system. After researching tap records, maintenance reports and meter installation records, no lead lines were found. Homes may still have a lead exposure if house plumbing was constructed of lead pipes or used lead solder.
Service Line Certification
Service Line Map
- May 14, 2015 Letter from Burgess and Niple, Inc concerning construction plans
- December 8, 2015 Letter from Burgess and Niple , Inc concerning Arsenic levels
- January 29, 2016 Letter from Bennett and Williams Environmental Consultants, Inc concerning Arsenic levels
- February 9, 2016 Letter from Burgess and Niple, Inc concerning Arsenic levels
- February 9, 2016 Letter from Bennett and Williams Environmental Consultants, Inc concerning Arsenic levels
- February 22, 2016 Letter from Burgess and Niple concerning sampling
Lead and Copper
Lead and copper primarily enter the water system through plumbing materials. Soft or corrosive water can leach these materials out of house plumbing, especially if the water sits in the pipes for long periods of time. To combat this leaching action, the City of Lancaster adds an polyphosphate blend as an corrosion inhibitor and a sequestering agent to prevent staining. In 1991 U.S. EPA changed the focus of the lead and copper testing to reflect the fact that most lead and copper sources are household plumbing. Prior to this time the lead and copper standard was 50 parts per billion leaving the water treatment plant to today's standard of 15 parts per billion for lead and 1300 parts per billion for copper at the customer's faucet. Lead and copper testing are done at a set amount of services annually. U.S. EPA regulations require that if 10% of the samples exceed the limits, the water system must institute corrosion control measures and if the lead limits are exceed the community must also provide a public notice including steps customers can take to minimize exposure to lead. These steps can include the following If water has sat in your pipes more than six hours, let the faucet run to flush the lines. U.S. EPA recommends that you flush the lines until the water runs cold.
Click here for the U.S. EPA fact sheet on Lead and Copper
Bacteria contamination is rare in a groundwater system by its nature. But bacteria can enter the system due to cross contamination caused by water line breaks or backflows of contaminations. To eliminate bacteria the City of Lancaster chlorinates the drinking water before it leaves the Water Plant and monitors for bacteria. In the case where a water line is depressurized, the City is required to issue a boil order to affected residents and perform additional testing until two samples are free of bacterial. The bacteria test takes 24 hours. Our system is designed to close off affected areas of the City so that only a small number of residents are affected by a boil order. For more information see the Boil Order
Ground Water Monitoring
In addition to our Water Treatment Plant monitoring, the City of Lancaster maintains a series of monitoring wells surrounding our wellfields within the one year time of travel. These wells serve as our early warning system to detect pollution before it reaches our wells. For more information on the Wellhead Protection program, click here.
Because of the importance of water to our community, we have a mandated emergency plan to cover emergencies big and small. We have survived blizzards, ice storms, wind storms and floods without missing a beat. Interconnections within our distribution system means that we can work around water line breaks and plant shutdowns. Our water storage system hold over the mandated 24 hours reserve of water even in a major failure water is available for customers and fire protection. Our emergency plan includes a procedure for notifying customers about emergency situations and water quality issues.